Gilderflukeco Frequency Shift Keyed/Remote Terminal Unit Manual de usuario

Busca en linea o descarga Manual de usuario para Audio Gilderflukeco Frequency Shift Keyed/Remote Terminal Unit. Gilderfluke&Co Frequency Shift Keyed/Remote Terminal Unit User Manual Manual de usuario

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 29
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 0
Frequency Shift Keyed (FSK) /
Remote Terminal Unit (RTU)
Preliminary Printed February 27, 1999
This is an Animation system with 128 digital outputs and (optional-
ly) sixteen 0-10 VDC analog outputs. It can be used in stand-
alone applications using its on-board EPROM or an external
source of FSK data for program storage. This unit can also be
used as an output device attached to a PC•MACs animation sys-
tem, receiving data sent to it through the DMX-512 or FSK inputs.
The FSK/RTU can be mounted in 1-3/4” of standard 19” rack
space. It requires 4-1/2 “ of space behind the panel. Power re-
quirements are between 12 and 24 VDC (18 VDC or greater if the
analog output option is installed). The current requirements are
determined by the loads attached to the unit. The FSK/RTU unit it-
self draws between 350 ma. and 1 amp, depending on the
number of front panel LEDs on at any one time.
This Animation System is used in one or more of the following three
modes:
1) Frequency Shift Keyed (FSK) Data Playback: To play animated shows
which have been recorded on any standard audio tape, Compact Disc,
LaserDisk, or other source of audio data. Sixteen to thirty-two 8 bit channels
of data can be played back using this unit. FSK data is normally generated
using a PC•MACs Animation Control System. When operating in this mode,
three relay outputs and/or the serial port can be used to start, stop and
rewind a tape deck, LaserDisk or Compact Disc players. Delays between
shows can be set for up to 9,999 seconds.
2) Remote Terminal Unit (RTU): Receive DMX-512 data transmitted by a
PC•MACs animation Control System, or any other source of DMX-512 data,
and convert it to individual digital outputs and (optionally) sixteen 0-10 volt
analog outputs. FSK/RTUs can be used to temporarily take the place of Brick
Animation Control Systems when programming a show from a PC•MACs sys-
tem. A single DMX-512 twisted pair is often more convenient to handle than
a multitude of temporary J6 ribbon cables.
3) Stand-Alone Animation Playback: A sequencer feature allows the unit
to play a show from an on-board EPROM memory. The FSK/RTU can be set to
play whenever either of the two data sources above stops. This allows an ani-
mated show to continue running in an ‘attract’ or ‘keep alive’ mode when it
isn’t playing any of the regular shows. This mode of operation can also be
used if you just need to run a single show continuously. The sequencer
EPROM is programmed using a PC•MACs Animation Control System.
GILDERFLUKE & CO. • 205 SOUTH FLOWER ST. • BURBANK, CALIF. 91502-2102 • 818/840-9484 • FAX818/840-9485
i of iii
0
8
4
C
2
6
A
E
0
1
2
3
4
5
6
7
8
9
A
B
C
D
E
F
fuse
fuse
fuse
fuse
fuse
fuse
fuse
fuse
fuse
fuse
fuse
fuse
fuse
fuse
fuse
fuse
0
1
2
3
4
5
6
7
0
1
2
3
4
5
6
7
FSK / REMOTE TERMINAL UNIT • GILDERFLUKE & COMPANY • GLENDALE , CALIFORNIA
1
2
3
4
5
6
7
8
Delay
Between
Shows /
Address
Heartbeat
Data Rec'd
Data Error
Stop
Play
Rewind
RS-422
Serial Port
0
1
2
3
4
5
6
7
8
9
A
B
C
D
E
F
0
1
2
3
fuses
Analog Outputs
Dipswitch
FSK / REMOTE TERMINAL UNIT • GILDERFLUKE & COMPANY • GLENDALE , CALIFORNIA
J-6 Digital Outputs
Channels 0-3
J-6 Digital Outputs
Channels 4-7
J-6 Digital Outputs
Channels 8-B
J-6 Digital Outputs
Channels C-F
J-6/A Analog Outputs
Channels 0-F
gnd
pwr.
stop
stop
rew.
rew.
play
play
dmx-
dmx+
FSK Data
Input
3950 / 7150
9375 / 12,500
Vista de pagina 0
1 2 3 4 5 6 ... 28 29

Indice de contenidos

Pagina 1 - Remote Terminal Unit (RTU)

Frequency Shift Keyed (FSK) /Remote Terminal Unit (RTU)Preliminary Printed February 27, 1999This is an Animation system with 128 digital outputs and (

Pagina 2

are what are called ‘insulation displacement connectors’. These simply snap on to an entirecable, automatically ‘displacing’ the wire insulation and m

Pagina 3

The supply line for each 1/4 J6/A is protected by a solid state circuit breaker (PTC Fuse)rated for 1 amp. You should treat each 1/4 J6/A as an ind

Pagina 4

Frequency Shift Keyed (FSK) Tape (or Disk) Organization:When operating in FSK mode, the system is constantly listening for data on the FSK input. Whe

Pagina 5

FSK/RTU CONFIGURATION:All commands sent to the FSK/RTU Unit through its serial interface take the following format. All charac-ters are sent in ASCII.

Pagina 6

COLOR SIGNAL NAME:LEFT WHITE SIGNAL GROUNDBLACK - SERIAL DATA OUT FROM FSK/RTU UnitRED + SERIAL DATA OUT FROM FSK/RTU UnitGREEN - SERIAL DATA IN TO RE

Pagina 7

Main Configuration Screens:-Gilderfluke & Company - RTU/FSK Controller - version 2.00 - copyright 1994 DCM-sequencer = 20h x 06450 frames for

Pagina 8 - 1/4 watt resistor

mands without having to enter all 80 characters. Doing so will conclude (not abort) the string entry com-mands. Al other commands are aborted by enter

Pagina 9 - AS A FUNCTION OF DUTY CYCLE

j) Force digital outputs on- This command is used to force any of the 128 digital outputs ‘ON’.No matter where the data comes from, an output that

Pagina 10

Summary of Setup Commands:a) tape deck pulseb) FSK/DMX dropoutc) FSK intershowd) FSK startupe) Minimum rewindf) Set FSK time delaysg) Enter stringsh)

Pagina 11

- String Setup -STRINGS are the ASCII characters and commands which you can tell the FSK/RTU send at the start orend of any show through its serial

Pagina 12

GILDERFLUKE & CO. • 205 SOUTH FLOWER ST. • BURBANK, CALIF. 91502-2102 • 818/840-9484 • FAX818/840-9485ii of iii

Pagina 13 - FSK/RTU CONFIGURATION:

Special String Characters:Within the strings there are nine ‘special characters’ which can be used. They are defined as follows:END-o-STRING: (00): Th

Pagina 14 - ONE or TWO STOP BITS

ASCII Characters to be Sent Out:When sending ASCII characters to the serial port, they translate into HEXadecimal as follows. The firsteight characte

Pagina 15 - Main Configuration Screens:

ASCII Characters to be Recieved:If you need to get a response from the serial port, you simply enter the character with bit seven set.The first charac

Pagina 16

- PIONEER LaserDisk COMMANDS -The Pioneer LaserDisk players all share a common command format. A full description of the com-mands can be found in th

Pagina 17

or a variety of other things. You can even build up a string which will tell the LaserDisk player to search foranother frame on the disk and fr

Pagina 18 - Summary of Setup Commands:

COMMAND MNEMONIC 1st 2nd 3rd 4th RESPONSE 2NDSEARCH SE 53 45 0D D2 8DSearches for the five digit frame number which immediately precedes this command.

Pagina 19 - - String Setup

- SONY LaserDisk COMMANDS -The Sony LaserDisk players all share a more or less common command format. A full description of thecommands can be found i

Pagina 20 - Special String Characters:

The format of this string is pretty much like that of the startup string, except the F-PLAY command hasbeen replaced by a STILL command for the LaserD

Pagina 21

EJECT42A 8A 83Opens the disk compartment. Returns 8A immediately, 83 when task is completed.EJECT ENABLE 274 8AEnables the ‘Eject’ button on the front

Pagina 22

- DECIMAL to HEXadecimal to ASCII to PERCENTAGE -The following chart shows decimal, HEXadecimal, ASCII and a few percentage equivalents to aid youwhen

Pagina 23

Front of the FSK/RTU ... 1Eight Position Dipswitch ...

Pagina 24

GILDERFLUKE & CO. • 205 SOUTH FLOWER ST. • BURBANK, CALIF. 91502-2102 • 818/840-9484 • FAX818/840-9485iv of iv

Pagina 25

On the Front of the FSK/RTU are:A) Eight Position Dipswitch which is used as follows:1) Initiate output test #1 when ON. Chases one digital output on

Pagina 26 - - SONY LaserDisk COMMANDS

C) Six LEDs Indicate:1) Heartbeat: Flashes continuously while the CPU is running. If it ever stops for more thana second or so, the ‘Deadman’ circuit

Pagina 27

for transmitting a checksum. The FSK/RTU can use this to verify that the data received fromPC•MACs has no transmission errors in it. If you address a

Pagina 28

17 violet channel 1 data bit 218 gray channel 1 data bit 119 white channel 1 data bit 020 black + unregulated power supply (protected to 1 amp)21 brow

Pagina 29

400600500300200100 0 2345876NUMBER OF OUTPUTSCONDUCTINGSIMULTANEOUSLYPER CENT DUTY CYCLEALLOWABLE PEAK COLLECTOR CURRENT IN mA AT 70ºCPEAK COLLECTOR C

Comentarios a estos manuales

Sin comentarios